Search results for "PARTIAL OXIDATION"
showing 10 items of 68 documents
Synthesis and support composition effects on CH4 partial oxidation over Ni–CeLa oxides
2015
Abstract Two series of Ni (6 wt%) catalysts supported over CeO 2 , La 2 O 3 and mixed CeO 2 –La 2 O 3 were prepared by co-precipitation and by wet-impregnation. The effect of the two Ni loading procedures on the catalyst structural properties was investigated by XRD, TPR and XPS. The catalytic behavior of the catalysts was tested in the methane partial oxidation reaction performed at 1 atm in a temperature range of 400–800 °C using dilute feed gas mixture with CH 4 /O 2 = 2 and gas hourly space velocity of 60,000 ml g −1 h −1 . Total methane combustion was observed within the 450 °C ≤ T ≤ 650 °C temperature range. Above 650 °C partial oxidation of methane started to occur, reaching at 80…
Chemical heterogeneities in nanometric titanomagnetites prepared by soft chemistry and studied ex situ : evidence for fe-segregation and oxidation ki…
2001
Nanocrystalline Fe-based spinels with composition Fe3-xTixO4 are synthesized using soft chemistry. Two steps are involved: precipitation in an aqueous solution followed by thermal annealing under a reducing mixture of N2/H2/H2O gases. Fe-segregation is found inside stoichiometric particles when the powders are studied ex situ; they exhibit a strong surface iron enrichment. This heterogeneity is related to kinetic effects linked to the difference of mobility between Fe2+ and Ti4+ cations during the partial oxidation of cations occurring ex situ. Stresses in the grains induced by oxidation govern the oxidation kinetics and lead to an abrupt compositional variation inside each particle. These…
Mo-W-containing tetragonal tungsten bronzes through isomorphic substitution of molybdenum by tungsten
2010
Mixed metal oxides based in Mo(W)–Nb–V–Te with tetragonal tungsten bronze (TTB) structure have been synthesized by a hydrothermal method from aqueous solutions of the corresponding Keggin-type heteropolyacids and further heat-treatment in N2 at 700 ◦ C. The materials have been characterized by several physico-chemical techniques, i.e. XRD, Raman, FTIR, SEM-EDS, and TEM. This procedure allows controlling the chemical species to be distributed in the different interstices of the TTB skeleton, which is a key factor to regulate the catalytic properties of the final solid. In this sense, the isomorphic replacement of Mo by W results in lattice parameter and crystal morphology variation, although…
Photocatalytic and photoelectrocatalytic H2 evolution combined with valuable furfural production
2023
In this work the photocatalytic (PC) and photoelectrocatalytic (PEC) reforming of furfuryl alcohol (FA) under environmental friendly conditions was investigated. Both H2 evolution and partial oxidation to furfuraldehyde were followed. For the first time TiO2 based photocatalysts were studied and the photocatalytic activity of home prepared photocatalysts was compared with that of commercial ones under both UVA and simulated solar irradiation. PEC tests were performed by using home prepared TiO2 nanotubes (TiO2 NTs) as photoanode and Pt free Ni foam as cathode to improve the Hydrogen Evolution Reaction (HER). Both the partial FA oxidation reaction rate and H2 evolution rate were normalized f…
Effect of the cerium loading on the HMS structure. Preparation, characterization and catalytic properties
2013
Abstract Ce–HMS mesoporous materials were prepared by incipient wetness method starting from HMS synthesized in acid condition. The effect of cerium quantity, in the range of Ce/Si atomic ratio 0.02–0.3, on its structure and properties was investigated. Results showed that the HMS hexagonal structure was maintained after the cerium adding. Furthermore, the surface area and the pore volume were reduced. The presence of the cerianite nanoparticles located within the HMS channels up to 0.05, thus covering the HMS surface at higher Ce/Si atomic ratio, was observed. The catalytic performances of the materials were tested in ethanol partial oxidation reaction.
Photoactivity of shape-controlled TiO2 in gas-solid regime under solar irradiation
2019
Abstract Differently shape-controlled anatase TiO2 materials were tested as photocatalysts under both simulated and natural solar irradiation. Their photocatalytic activity in 2-propanol and propene partial oxidation and in the complete mineralization of acetaldehyde appears to increase with decreasing the shape control of the TiO2 material. This insight seems to be related to the residual presence of the templating species (fluoride anions) employed during the preparation of the shape-controlled TiO2 materials. In fact, the calcination of the powders, leading to levelling of the fluoride ions content, but also to a remarkable surface area decrease, gave rise to an increase of photocatalyti…
Alkaline treatment as a means to boost the activity of TiO(2)in selective photocatalytic processes
2020
In this work, the activity enhancement of TiO(2)photocatalysts by alkaline treatment has been investigated. Commercial (BDH, U.K., anatase phase) TiO(2)samples, treated in alkaline solutions of NaOH at different concentrations and temperatures, were tested for the photocatalytic partial oxidation of 3-pyridinemethanol in water under UVA irradiation to form vitamin B-3. Photocatalyst characterization has been carried out by XRD, BET, TEM, TGA, photoluminescence, FTIR, Raman, DRS, EPR and photocurrent measurements. The alkaline-treated samples showed an increased activity of up to 7 times (by considering first order rate constant values) compared to untreated BDH and the superior performance …
Nanosponge-C3N4 composites with improved photocatalytic activity for selective partial alcohol oxidation in aqueous suspension
2022
Composites of C3N4 with nanosponges based on β-cyclodextrins containing a 5% w/w of C3N4 were synthesised, physicochemicaly characterised and tested as heterogeneous photocatalysts for the degradation of 4-nitrophenol and for the partial oxidation of 5-hydroxymethyl-2-furfural and veratryl alcohol. The results outline a synergistic effect in terms of conversion and selectivity. The association of the nanosponges with the C3N4 enhances the photocatalytic activity of the semiconductor, possibly due to the local concentration effect occurring on the photocatalyst surface that would involve a concentration into the nanosponge matrix ca. 500 times larger than in the solution bulk. Composites of …
The influence of the anatase nanoparticles boundaries on the titania activity performance
2014
Metal oxides structures, formed by ordered self-assembling of crystalline nanoparticles aggregates, are attracting growing attention in fields such as catalysis or solar cells. The properties of these structures are influenced not only by their morphology and nanoparticles composition but also by the assembled particles boundaries. In order to determine the influence of these boundaries on the structures properties, the present investigation has been devoted to study the characteristics of anatase nanoparticles boundaries in titania aggregates prepared by TiCl4 hydrolysis at low temperature. Proton magic angle spinning nuclear magnetic resonance and high resolution transmission electron mic…
Kinetics of 4-Methoxybenzyl Alcohol Oxidation in Aqueous Solution in a Fixed Bed Photocatalytic Reactor
2010
WOS: 000280384800004